Re: SHC Connection to OnSTEP STM32


Howard Dutton
 

The Wiki describes the connection point.
https://onstep.groups.io/g/main/wiki/Smart-Hand-Controller

The RJ12 on the SHC is for an optional pass-through ST4 port guiding interface (for plugging a camera into for example.)  The 3D printed case only works if that jack is omitted.  The cable exists the PCB bottom (left side as shown below) between the four holes.  The four holes are for nylon ties (zip strips) as strain relief, this allows for a nice compact SHC case.

Join main@onstep.groups.io to automatically receive all group messages.