Re: SHC Connection issues

Dave Schwartz
 

In the case of the SHC, its usually reversal of the one on the controller PCB that causes the problem. The ones actually on the SHC are for the buttons and the auxilliary ST4 port.

On 2020-06-30 6:40 a.m., Howard Dutton wrote:
On Mon, Jun 29, 2020 at 07:37 PM, <Matthewabey@...> wrote:

Thank you guys so much that was my issue, I had one resistor array
backwards.

Glad you are up and running.

There was a note in the SHC Wiki build instructions about this already, it's now highlighted in yellow.
I also widened the SHC PCB silkscreen around the RPs' pin 1 to really make it stand out.

Join main@onstep.groups.io to automatically receive all group messages.