Re: Onstep Telescope+Focuser using together?
planetibo@...
On Wed, Jul 1, 2020 at 07:51 AM, <thomas.westerhoff24@...> wrote:
The right parameters for "com0com" and "hub4com":
COM3 is my Com port of CHG340-MKS Gen-L v2.0
-Create Virtual port with com0com :
COM9 > CNCB0
COM10 > CNCB1
-Launch hub4com
hub4com.exe --baud=9600 --octs=off --route=All:0 --route=0:All \\.\COM3 \\.\CNCB0 \\.\CNCB1
-Now, i can configure "Poth Setup" with the "Scope Connection" on COM9 and "Focuser Connection" on COM10.
Hi @ all,
I'm also interested in that software if it really works
Hello,
There is this solution that I tested successfully last night.
http://com0com.sourceforge.net/The right parameters for "com0com" and "hub4com":
COM3 is my Com port of CHG340-MKS Gen-L v2.0
-Create Virtual port with com0com :
COM9 > CNCB0
COM10 > CNCB1
-Launch hub4com
hub4com.exe --baud=9600 --octs=off --route=All:0 --route=0:All \\.\COM3 \\.\CNCB0 \\.\CNCB1
-Now, i can configure "Poth Setup" with the "Scope Connection" on COM9 and "Focuser Connection" on COM10.