Re: OnStep up and running!!!


Basic Hand Controller question...

I also have made a basic hand controller... I did not include the resistor network and used in config.h:
#define ST4_INTERFACE                 ON //   
#define ST4_HAND_CONTROL        ON  //

unfortunately the handcontroller does not work...

next step would be introducing the resistor network? will it cause problems if I use it?
I read here that it may cause problems with booting or is this solved?

Unfortunately I have ordered 3.3kOhm (instead of 2.2kOhm)... will it cause problems if the resistance is too high?
in config.h I put:
#define ST4_INTERFACE                 ON_PULLUP
#define ST4_HAND_CONTROL       ON 

thanks in advance...

Join to automatically receive all group messages.