Thanks, Mark, I found them on Digikey. They have several of them and are a bit confusing too. Still looking at specs in detail. Prasad

Geo Do you know any cable that does not harden (insulation) when used in winter weather? Long ago I had a Losmandy G11 and it came with its Losmandy control. The coiled cables for it remained flexible

A couple of nights ago, (on Friday night) I was out on my deck running my OnStep driven Vixen GP mount for a few hours and I got this "Unknown" error. This was not the first such occurrence. It has ha

Purely of academic interest, I have seen a solar tracking PV panel system in Las Vegas when I had gone there on work some time ago. It is massive and located right in the heart of Las Vegas. Owned by

I have two SHC units, both running ESP32, and kits were from my good friend George Cushing. Today I uploaded SHC firmware using the latest "Master" version into one of my ESP32 based SHC. I connected

Oops, wrong reply, was meant for someone else, my apologies... Prasad

Here is the Ralph Peterson drawing

No worries, I replied to you based on my own experience.

Read the very first item on this page https://onstep.groups.io/g/main/wiki/7118

Beautiful work. Thanks for posting pictures. What is the type of wood used by you? Prasad Eastern PA, near Philly

Howard Initially, I got confused but then it made sense. For example, we are in the Eastern Time Zone and our time is -5 hours from UTC. In other words, to get UTC we need to add 5 hours to our local

Several months ago I made an SHC using the ESP32 based kit from my good friend George Cushing. My SHC worked well but the pushbutton caps that went on the pushbuttons were either too loose and did not

yes

Piotr, You can reverse the two wires that go to one of the two phases of your DEC motor. That was what I had done. No need to flash.

Losmandy G11 mounts are so well made and sturdy that they can easily outlast you (unless of course, someone has wrecked it, which BTW, is not easy). I bought one a couple of years ago only to realize

And, guiding done with?

#backlash

Wow, that is wonderful. Can you tell me what is your imaging device?

#backlash

Thank you

Khalid Why do we need Boot0 pins to be wired by a cable finally ending at the tiny switch on the PCB? Can't we just use the jumper on the Boot0 pins on the STM32 board - simply physically move the jum

As I read the discussion on GPS feature I am feeling tempted. I wish a GPS module could be included within the SHC to enable OnStep to start working without the need to use an Android phone to set the