Cheers. I’ll give it a go.

Hi, Tried 3 star alignment with the android app. Picked a star and hit goto. Slews to the first star, I adjust to get it centre in the eye piece and then click align. For the second star i just picked

Cheers. I’ll see if i can track down an android phone and try it that way. thanks

Hi, When I do the following i get “align fail”: Open up Gotomote, connect, set site, set time, start 3 star alignment. Select star from list, press goto, off it goes. Once finished slewing I press Ali

Thanks George, I worked it out eventually. I had to use the pinout info of the Motor driver which identified A1,A2,B1,B2 and just used a multimeter to bell it out to work out which pin is which on the

Hi, I have stepper motors that just have loose wires. The data sheet designates the colours as Black(A+) Green(A-) Red(B+) Blue(B-) I can’t find a pin-out for the STI connector on the Fysetc S6. I’m n

Hi Everyone, I have Nema 17 (200 steps/ 1.8 degrees) with integrated 100:1 planetary gear box (17HS19-1684S-PG100) with a spec sheet current of 1.68Amps. I'm not really understanding the Irun & Igoto

#configuration

Hi Dave, Thanks for the quick response. I can see now that there is two rows of breakouts. I couldn't understand why there was a GND TXD and a 100 GND. This is my fault for not building anything for s

Hey Peeps, Haven’t built a big electronics project for about a decade and my my how things have changed. Somethings are easier and somethings have become harder. I’m currently stuck working out how to

Thanks, I might go for the TMC5160 don't seem to be too expensive and i'd rather overate the driver. I haven't looked into how onstep works with the motors/drivers yet. Can you just set the microsteps

#dob

Hi Dave, Thanks for the detailed response. I can get all of that from ALIexpress, i'll copy. Do you ever get a gps to work with the Fysetc 2.0?

#dob

Hi Guys, I've started my Dob conversion using Prosperguy thingiverse printed gears. I have to do some fusion3D mods for it to fit my scope, never used it, bit of a learning curve. Waiting for some stu

#dob