I'm not sure if OnStep is going to expect to receive data from an SPI driver but I do know that it does not expect to hear anything from non-SPI drivers (and the electronics don't care if nothing is t

#EQ5 #fysetc

Hi, I will keep it short: - TS100 doesnt have PPS signal - It is there just for illustration (at the moment I am testing another GPS module with PPS) - LEDs are connected as you said - directly to the

#fysetc

Hi Dave, thanks for the fast response. The serial monitor indeed gives me the response : On-Step# So the firmware was flashed successfully and the board is working with the onstep firmware. Now i can

#fysetc

Disregard the above. I was able to get it to work on PA 5, 6 and 7. I had MISO and MOSI swapped.

#fysetc

So there were few issues I saw not only did the COM port driver vanish, but an unknown device appeared in USB hub section of device manager. I had installed STM's virtual COM port driver. It is very p

#fysetc

Hi Khalid, that is actually not the case. Controlling and switching the output is ok - for example, I run a fan on another aux and that is easy to control and works as expected. It is just the rutine

#fysetc

Check the design now :) Nuts and bolts are also added now...

#fysetc

Hello everyone :) My first post here. I am owner of EQ5 which I am working on right now to implement Onstep - based on Fysetc S6 board. So far, steppers, gps, status led 1 and their configuration runs

#fysetc

As Howard said, OnStep cannot use the UART interface. You can still use the TMC2209, but you are limited to microstepping of: 64,32,16,or 8. Not a real limitation though, since it covers the range we

#mks #tmc2209 #fysetc #uart