Hi Howard Is it possible for you to check why i can't get the temperature through the command :G1# I'm using the Adafruit si7021 and the weather is displaid on the weather panel but impossible through

Some update after further testing : I tried to put SQM OFF in config.h : no success : frequent reboots whatever the status of the 2 power relays (On or Off). No visible sign of these reboots when the

Good morning Howard the problem is that if I turn off the Watchdog the OCS web page fails and freezes... I had no relay problem at all with my previous configuration and the same relay wiring

All commands to get weather information work fine except temperature...

That's exactly what i need, thanks Howard ! I'm going to test these commands and let you know In one post you talked about a project of builiging an OCS on an ESP32, is it for a distant future ? :);

The OCS doesn't do XML :) What it does have is an LX200 like protocol with :xxxx# framed commands and # terminated responses. You can see the available commands in Command.ino, they include commands

I'd turn the watchdog off, the feature is there but it working properly depends on Mega2560 firmware support that isn't always present. Sounds like a hardware problem. There are a wide range of

Hello, I have used OCS up to now with success with the Roof and Power functions only. I was able to activate 2 relays for the 12 V power supply of the telescope mount and accessories, and for the 220

Hi Howard, I’m building an Allsky just next to OCS, from time to time the camera under the dome will need some heating when humidity and temperature reach a certain level. An idea has crossed my

I have made the modification and it works as I wish now. Thanks

Running full OCS on a ESP32 would be terrific, this MCU is cheap and fast. Would you intend to build a PCB based on the ESP32, the 38 pin version i suppose, with selected features (as the Mini in

No plans for the Teensy but adding the capability to run the OCS on the ESP32 has crossed my mind. The Ethernet webserver in the OCS is a mirror of the ESP8266/ESP32 WiFi, not exactly the same, but

That's what I want to hear.

Yes that capability is in the OCS.ino file... Probably should make it something you setup in Config.h since the need to do so comes up quite often.

Sorry I should have looked first at the this forum where this issue was already reported and answered...

Hello, All my relay outputs are high when not activated, and turn low when activated. Is it normal? Can it be set the other way round?

Hi Howard, In the future is there any wifi integration in your roadmap on OCS ? I'm building a second OCS wich would be a nomad version mainly to get the weather webpage. I was wondering if using few

I will given adding this feature consideration at some point.

Hi! Is there any chance in the future any slave mode or connecting to the OnStep? I'm thinking about close the roof after parking, and open before unpark. And parking on a safety closing. Is this an

This time has arrived. All suggested changes/fixes are addressed in the code but untested. I expect it'll all just work. Some of these changes are kept disabled by default and must be enabled in