That's a tall order! Note that I've really been too busy with OnStepX development (and other challenges with life) to shift my attention to the OCS in quite some time. OnStepX is apparently getting

Thanks for creating this group. I have a 14 year old Foster Systems roof controller that refuses to allow me to up grade the firmware. They do not support it, so I'd like to setup my DIY in less than

Talking about GPS i mentionned an i2c interface actually in my mind it was a TX-RX communication, there are 2 physical interfaces on the board...

Nice !

Thank you for your reply. Ad. 2 I think about change "Dome simulator driver", possibly merge some code from "onStep LX200 Driver" to control OSC. I have found "Command" file where are commands to

I'll keep these feature requests in mind when I revisit this project.

Doesn't exist AFAIK. I don't use Linux for astro stuff. I think you're asking is it possible to control an OnStep mount with the OCS, if so the answer is no that doesn't exist but it is a feature I

Hello, I have built onStep for my old mount. Im verry happy with results. Now I would like to build OSC. I have few questions. 1. Is possible to control OSC from EKOS (indilib) ?. Is driver for

Hi Howard, In my installation the ntp feature to synchronize time has nerver been a real success, i'm always several minutes late , i tested several ntp servers and it doesn't change anything. Would

Concerning direction, not obvious to get it properly i know. Anyway thank you for the code that allows to handle mutliple hotwires.

Seems to me wind direction with this is impossible. Adding more would be follow the same pattern, trivial.

So great and so nice ! I’m going to order a second sensor and test the changes. I was not sure this feature was possible so I prefered waiting. May I ask a question ? I don’t know the modern

I've never even thought about using it like that but if it works, great. Basically any digital (or "analog" for that matter) pin on the Mega2560, not used for other purposes, can provide the EN and

Guess the following should work. It takes the higher windspeed from the two devices and returns that... //

Yes, it is configured to pin 11, some devices like a Zyxel router dont recognize it as a conecetd device but still works at the configured ip, the results are the same if i config for static ip

Hi Howard, Experimenting the modern device hotwire sensor which is actually oriented east-west in my installation i was wondering if adding a second one north-south would be possible in OCS

I tested to work a stepper motor to open/close roof using the ROR_POWER_RELAY pin PWM to a DRV8825 step pin, i took pin 3 and 5 for dir and en and added digitalWrite code for those pins on Roof.ino

I will come back around to the OCS for a good once over, and when I do things like this will be built-in.

Works fine fine fine, i implemented it for both current and voltage, thanks for your time, congrats for your knowledge.

You did wire in and handle the W5500 reset pin right? Other than that it seems to be an library level or below issue and not hardware I've ever tested the OCS with. We do use the W5500 with somewhat