Without knowing what exactly is attached I can't check code... Barometric pressure isn't working; it works for my BME280. Wind speed isn't working; it works for my Modern Devices Rev.P on the T4.1

I did a fair bit of testing this morning and most of what I need the OCS to do seems to be working correctly now (software and hardware.) Roof seems to do what it should. DC motor MOSFET works. Nice

I guess there's an 80% chance the revised OCS board is actually ok and everything works. No-one has ever built one to know for sure, so I call it "beta"... https://easyeda.com/hdutton/ocs3

Howard, when will the link for the new PCB be ready to order? Thanks Nino

Nice to see the new OCS pcb soldered ! Good job ! I look forward to knowing about the results when you install it. Thanks for sharing Howard

There were a few mistakes on rev 0 but nothing that couldn't be worked around. OCS software more or less works too, I have the webpage up but not sure if the logging is really right. If all goes

OK I decided to flash the mega with my usb1 port instead of the usb 3 one and the mega has recovered, interesting ! The mega is now stable and i can reach the webpage All panels are working : status

192.168.4.50 is my computer address, i'm pinging 4.10 (OCS board)as you can see in the screeshot

Oh... I see in the window title it's 4.10, other than that no idea.

The debug messages are saying the OCS is at 192.168.4.10 and you're pinging 192.168.4.50.

Hi, I'm testing OCS on the Mega, i've desactivated all sensors, power panel and light panel. The debug mode is on "VERBOSE" status but no clear information. As we can see in the screenshot no ping in

Maybe we can focus on the mega for a week and then test the compilation on The Teensy board I know it's a job to debug several boards at a time and especially on a very new board like the Teensy

And from a hardware standpoint they have a lot more in common with each other than they have with the T4.1.

Note: The chances of some given I2C device library having a problem running/compiling on the T4.1 is greater than an issue on the T3.5 or T3.6 ... those have been around a lot longer.

Talking about the Teensy 4.1 the compilation is now ok in the 3.b version, a light error concerning the TSL2591 (not with the Mega) but non blocking I'll test this version tomorrow on the mega 2560

Also, I added the BMP085 (supports BMP180 also) to the OCS, both thermostat and weather. Uses the Adafruit library.

The Mega2560 is fast enough to run the OCS. The Teensy3.6 is about 60x faster with far more resources (RAM especially.) The T4.1 is about another 6x faster than a T3.6. The OCS doesn't do anything

I’ve also ordered a Teensy 4.1 with headers, less expensive than the 3.6 and quite interesting

I'll probably use a T4.1.

Howard, which Teensy are we looking at for the new OSC3. I might as well order a couple of them to have for testing. Thanks Nino