Newb here

Ok, found your registration... I emailed a link to a new set of drivers to correct this issue.

Email me your valid ASCOM driver registration information and I'd be happy to take a look at the issue.

Hi howard I am with this problem when I want to configure the ASCOM roll roof driver In SGP it works perfect, but in the ASCOM control panel and in NINA it doesn't let me configure it. What I can be

This weekend I finished installing most of the control functions for the new OCS3 hardware at the observatory. The thermostat inside heat, roll-off roof, and warm and observing room red and white LED

The OCS hardware is on EasyEDA, its still beta so hopefully it all works acceptably, AFAIK it does. The OCS doesn't use the OnStep ASCOM drivers. And unlike OnStep, the ASCOM drivers for the OCS are

Good Morning Howard, any idea when the Beta OCS Board and BOM will be ready to purchase and will this new OCS work with your ASCom driver. Just asking due it takes a while to get the parts, just

Hi Actually I have a doubt concerning the RevP. I’ll check the wiring, I suspect a cable problem, I’ll check that tomorrow. The other 2 sensors not working -the bmp180 : I’m using the bmp180

Without knowing what exactly is attached I can't check code... Barometric pressure isn't working; it works for my BME280. Wind speed isn't working; it works for my Modern Devices Rev.P on the T4.1

I did a fair bit of testing this morning and most of what I need the OCS to do seems to be working correctly now (software and hardware.) Roof seems to do what it should. DC motor MOSFET works. Nice

I guess there's an 80% chance the revised OCS board is actually ok and everything works. No-one has ever built one to know for sure, so I call it "beta"... https://easyeda.com/hdutton/ocs3

Howard, when will the link for the new PCB be ready to order? Thanks Nino

Nice to see the new OCS pcb soldered ! Good job ! I look forward to knowing about the results when you install it. Thanks for sharing Howard

There were a few mistakes on rev 0 but nothing that couldn't be worked around. OCS software more or less works too, I have the webpage up but not sure if the logging is really right. If all goes

OK I decided to flash the mega with my usb1 port instead of the usb 3 one and the mega has recovered, interesting ! The mega is now stable and i can reach the webpage All panels are working : status

192.168.4.50 is my computer address, i'm pinging 4.10 (OCS board)as you can see in the screeshot

Oh... I see in the window title it's 4.10, other than that no idea.

The debug messages are saying the OCS is at 192.168.4.10 and you're pinging 192.168.4.50.

Hi, I'm testing OCS on the Mega, i've desactivated all sensors, power panel and light panel. The debug mode is on "VERBOSE" status but no clear information. As we can see in the screenshot no ping in

Maybe we can focus on the mega for a week and then test the compilation on The Teensy board I know it's a job to debug several boards at a time and especially on a very new board like the Teensy