On Sun, Oct 3, 2021 at 03:44 PM, koal01 wrote: I didn't know i could copy all my Power panel from OCS 2 and paste it to OCS3, nice !I only changed Config.h settings where required or very desirable.

Magical, nearly everything solved. I didn't know i could copy all my Power panel from OCS 2 and paste it to OCS3, nice ! The sensors errors have also disappeared, for the bmp280 after a google

On Sat, Oct 2, 2021 at 02:12 PM, koal01 wrote: Howard, i was using in OCS 2 the power panel in config.h for specific use and i really did like as they relay were named as Device 1, 2, 3 etc.. My

I'm guessing these are both related to your not having the proper libraries installed for the Arduino IDE. I think you might have realized/fixed this but not sure, at any rate I can enable both of

Hi Fernando ocs 3 is in the master branch

Hi Howard, is there a link to the new OCS, I would like to try it on my spare set up. Just checked the GitHub, is the 2.33 version the latest? Thanks Nino

Feedback : The wind sensor RevP is not operational I also tried to activate ETHERNET_RESET_PIN and CONNECTION_CHECK_HOURS parameters in the extended config.h and the IDE display errors When these

Howard, i was using in OCS 2 the power panel in config.h for specific use and i really did like as they relay were named as Device 1, 2, 3 etc.. My shelter is not a standard In OCS3, the power panel

Howard, i have errors with 2 sensors, the MLX90614 and the bmp280 (actually i'm using the bmp180 but i downloaded the bmp280 lib for the test, the bme280 works fine as well as other sensors. Error on

I've just deleted 2 messages i send since i couldn't compile but seeing the arduiino IDE error it was a library problem with the digitalWriteFast lib, i downloaded it and the compilation is ok

Yes for weather but untested, look in Config.h they are listed. Only Bme280 for thermostat now, easy to add others though. Reminds me i should attach thermostat pressure to weather as it applies.

Are the bmp180 and si7021 sensors compatible with ocs3 ?

Speaking of new features... one of them is due to using the Sense class (from OnStepX) for digital inputs: Now these digital inputs have a built-in ability to filter noisy conditions. Normally, you

I have things mostly working I think (on a Mega2560). The BME weather sensor works (new design/code there so that's good.) The website and charts work. NPT works. Relays almost work. The fast relay

Never mind, i'm candidate for bugs and crashes LOL , ok just tell me when i can test OCS3 !

On Thu, Sep 30, 2021 at 02:19 AM, koal01 wrote: i'll try the update tommorrow and let you know.It's very much a work in progress at this point, lots of bugs, so you should wait for a little while

Hi, i'm currently at the 2.3i version and I'm a candidate to the new version 3, i'll try the update tommorrow and let you know. Always a pleasure to test the latest improvements Thank you for ALL

Howard, I am happy that your project is top notch. I look forward to buying a board, as it looks like the most professional design (hardware) I've seen! My current plan is to get a simpler Arduino uno

I've started work on the OCS update, it's on Github as the master branch. The last stable OCS is now release-2.3 and the default branch, which is a good thing as this new version 3 of the OCS will

Ok for analog inputs changes, very good ! I confirm the Teensy 4.1 is cheaper than the 3.6, i was surprised about that, it is on the way as well as the w5500. Ok for the green connectors with screws