BME280 DHT11 Water Sensor Rainwater Module Rain Detection Module 3.3V-5V Infrared Thermometer - MLX90614 Sky Quality Meter TLS237

Hi Howard, I have a question on which ESP32 Module to use, ESP Wroom32 has 38 pin outs and the ESP32 Dev.Kit v1- DoIt has 36 pin outs, does it matter which one to use, I have both of these modules. I

Good Morning Howard, any idea when the Beta OCS Board and BOM will be ready to purchase and will this new OCS work with your ASCom driver. Just asking due it takes a while to get the parts, just wante

Howard, when will the link for the new PCB be ready to order? Thanks Nino

Howard, which Teensy are we looking at for the new OSC3. I might as well order a couple of them to have for testing. Thanks Nino

Got it, thanks Howard

Just a quick question about the section on Thermostat, is there a reason to use a BME280 instead of the BMP280 or DHT11? I guess the question for inside the Observatory do we really need the BP? I hav

Thanks, I found it. Looks like I need to get a Teensy board. Nicely laid out script. Looks like VS Coding.

Hi Howard, is there a link to the new OCS, I would like to try it on my spare set up. Just checked the GitHub, is the 2.33 version the latest? Thanks Nino

That is exactly what mine did, after three megas,two shields and three pc's, the issue that I discovered was my weather page had an error somewhere in the coding and a bad bme280 sensor. Might want to

I am running mine set up with hard wire from router to 8 port switch, no wifi. I checked all the ports on the switch, they all show connectivity. I am also using the 2.3i. Thanks Nino

Yep, I tried that, different ports and cables even hooked it up straight to router port. I can ping ip address shows no errors, I Loaded new fresh sketch with no changes, even reformated sd card, debu

I had mine working on the test bench for two weeks with no problems. Even had it connected to several sensors and again no reboots. So I grabbed and installed it in my observatory with no sensors conn

Hanif it should show your ip address as your server and not the subnet ip here is my info. Nino

Switched these to ON m(config.h) and monitor for any errors on you serial windows. #define DEBUG_SD ON // #define DEBUG_WEBSERVER ON /

Had mine running without sensors attached from thursday to monday morning with no reboots, Monday I added my sensors and had two reboots since. again mine is connected to my workbench pc, so I dont kn

FYI, mine is still running no reboots. tomorrow I will start adding the sensors and RTC clock back and bench test it over the weekend. Last thing, I will had my relays. I dont know what happened to my

Ditto, I had a lot of time outs to the server, it was not the internet shield that was messed up. I had to start new, I am bench testing and running 2.3h without any sensors or rtc. just the mega and

I just did a test on the internet shield, looks like I need a replacement. Nino

Well I had to revert back to OnCue OCS 2.1d, I was having time out issues(both IE and Firefox), and reboots in my system (watchdog was OFF). My weather charts were messed up. The system is back up, lo