Hi howard I am with this problem when I want to configure the ASCOM roll roof driver In SGP it works perfect, but in the ASCOM control panel and in NINA it doesn't let me configure it. What I can be d

Newb here

I've been working on the OCS again over the past couple of weeks and have added more weather sensor support. There is now support for Modern Device's "hot wire" type anemometer. There is now support f

Hi, I'm testing OCS on the Mega, i've desactivated all sensors, power panel and light panel. The debug mode is on "VERBOSE" status but no clear information. As we can see in the screenshot no ping in

Howard, i was using in OCS 2 the power panel in config.h for specific use and i really did like as they relay were named as Device 1, 2, 3 etc.. My shelter is not a standard In OCS3, the power panel h

Howard, i have errors with 2 sensors, the MLX90614 and the bmp280 (actually i'm using the bmp180 but i downloaded the bmp280 lib for the test, the bme280 works fine as well as other sensors. Error on

Hi Howard Could you tell me what I have to do to turn on the pullups on the digital input pins? I don't know how to do it and if that change can be made. Thank you

Thanks for creating this group. I have a 14 year old Foster Systems roof controller that refuses to allow me to up grade the firmware. They do not support it, so I'd like to setup my DIY in less than

Hi Howard, In my installation the ntp feature to synchronize time has nerver been a real success, i'm always several minutes late , i tested several ntp servers and it doesn't change anything. Would i

Hello, I have built onStep for my old mount. Im verry happy with results. Now I would like to build OSC. I have few questions. 1. Is possible to control OSC from EKOS (indilib) ?. Is driver for indili

Hi Howard, Experimenting the modern device hotwire sensor which is actually oriented east-west in my installation i was wondering if adding a second one north-south would be possible in OCS environnem

I tested to work a stepper motor to open/close roof using the ROR_POWER_RELAY pin PWM to a DRV8825 step pin, i took pin 3 and 5 for dir and en and added digitalWrite code for those pins on Roof.ino ta

I installed the USR-ES1 ethernet adapter, it has W5500 chip, works well but i have a little issue with it when conected to any router in DHCP mode (i use "Ethernet.begin(m);" instead of "Ethernet.begi

Hello Howard, im getting very different values for voltage and current reading, im using 2k2 and 220 Ohm for voltage and ACS712 20A (0,1V/A), some instant measurements differs in about 1V/1A from othe

Hello, I have used OCS up to now with success with the Roof and Power functions only. I was able to activate 2 relays for the 12 V power supply of the telescope mount and accessories, and for the 220

Hi Howard Is it possible for you to check why i can't get the temperature through the command :G1# I'm using the Adafruit si7021 and the weather is displaid on the weather panel but impossible through

Hi Howard, I’m building an Allsky just next to OCS, from time to time the camera under the dome will need some heating when humidity and temperature reach a certain level. An idea has crossed my mind

Hello, All my relay outputs are high when not activated, and turn low when activated. Is it normal? Can it be set the other way round?

Hi Howard, In the future is there any wifi integration in your roadmap on OCS ? I'm building a second OCS wich would be a nomad version mainly to get the weather webpage. I was wondering if using few

Would it be a big deal to have option to flip the x axis orientation so the newest data is on the right? I guess I'd prefer to just have the time stamp on the x axis vs. "units in the past" to the rig